These forums are read-only. Please send questions and feedback by email.

User Commands not working in Dual Pane Mode

Use this forum to ask any questions and to submit bug reports

Moderator: vuser

vuser
Posts: 38
Joined: Sat May 01, 2010 8:11 pm

User Commands not working in Dual Pane Mode

Postby vuser » Sun May 02, 2010 8:14 pm

Yesterday I was in dual pane and tried to select two files , one in each pane, and pass the files to a User Command. But that doesn't seem to work.

FileViewer
Site Admin
Posts: 287
Joined: Fri Apr 30, 2010 5:50 pm

Re: User Commands not working in Dual Pane Mode

Postby FileViewer » Sun May 02, 2010 9:34 pm

Yesterday I was in dual pane and tried to select two files , one in each pane, and pass the files to a User Command

User Commands are usually only executed on the "current" pane.

For them to work on files in *both* panes, you will need to create a separate User Command and use the %1F and %2F command options.

Have a look at the "Dual Pane (Split Mode)" section of the Help file.

Regards,
Charles.


Return to “General Support”

Who is online

Users browsing this forum: No registered users and 22 guests